Hurst sits in the heart of mid-Tarrant County, right in the middle of the HEB corridor between Fort Worth and Dallas. Our Dallas office at 14875 Preston Rd, Suite 550 serves Hurst homeowners directly, and our crews are in the area regularly. The drive is about 25 minutes, and we run jobs in Hurst, Euless, and Bedford throughout the week. The geology under Hurst is dominated by the Goodland Limestone formation with pockets of Eagle Ford-derived clay in the topsoil. That combination creates a specific kind of foundation problem: the limestone itself is stable at depth, but the clay layers sitting on top of it shrink and swell with moisture changes, pulling your slab in different directions.
Most of the housing stock in Hurst went up during the 1960s and 1970s, when the city experienced its biggest growth period. Those slabs are now 50 to 60 years old. They were built to the standards of that era, which means less reinforcement and less soil preparation than what modern building codes require. If you have a home in Hurst with doors that are sticking, cracks running through the drywall, or floors that feel uneven when you walk across them, the foundation is likely settling. But not every crack means you need work done. Plenty of older homes have cosmetic cracks from normal concrete curing that never get worse.
We offer a free inspection with no obligation. Our crew takes elevation readings across your entire slab, checks your grading and drainage, and evaluates the soil conditions around your perimeter. Everything goes in a written report. If piers aren’t needed, we’ll tell you straight. We have done over 20,000 inspections across DFW and walked away from a lot of jobs that didn’t need repair. When your home does need work, we use one of our three engineered pier systems and get most jobs done in a single day.
Hurst is located in central Tarrant County on the eastern edge of the Goodland Limestone formation. Unlike cities further east that sit directly on Eagle Ford Shale, Hurst has a limestone base with weathered clay layers on top. Those upper clay layers are the problem. They contain enough montmorillonite to swell significantly when saturated and shrink back hard during dry spells. The limestone underneath doesn’t move, so you end up with a slab caught between stable bedrock below and reactive soil on the surface. That mismatch is what drives most of the settlement we see in Hurst.
🟤
Weathered Clay Over Goodland Limestone
The clay topsoil over Hurst’s limestone base swells and contracts with every rain and drought cycle. The limestone underneath stays put. That difference in movement creates uneven pressure under your slab. Homes closer to the Trinity River floodplain in southern Hurst tend to have thicker clay deposits and more severe issues.
⛰️
Goodland Limestone at Shallow Depth
In parts of Hurst, limestone sits close to the surface. That sounds like it would be good for foundations, but it creates problems when builders in the 1960s and 1970s poured slabs directly on thin soil over rock. The slab has almost no buffer between it and the bedrock. Any clay movement in those thin layers gets transferred straight to your foundation with nowhere to absorb the stress.
🏠
The 1960s-70s Housing Boom
Hurst grew rapidly after World War II and hit its stride in the 1960s and 1970s. The city’s population tripled between 1960 and 1980 as families moved into new subdivisions throughout the HEB area. Those homes are now 50 to 60 years old. The slabs were poured with less rebar and less soil prep than current code requires. After decades of clay movement, a lot of those original slabs have reached the point where they need support.
🌧️
Tarrant County Drought Cycles
Central Tarrant County gets hit by the same drought-to-deluge patterns that affect all of DFW. The summer of 2022 dried the clay under Hurst homes to the point of deep cracking, then fall rains saturated everything fast. That rapid swing from bone-dry to soaked is the most damaging thing that can happen to a slab on reactive soil. We saw a spike in calls from Hurst and Bedford homeowners that winter who had never had a foundation issue before.
Drainage is a big factor in Hurst. Many of the older homes have mature trees with root systems that pull moisture from under the slab, and original gutters that dump water right at the foundation line. If your yard slopes toward the house instead of away from it, settlement speeds up. We check drainage during every free inspection.
Signs Your Hurst Home May Need Foundation Repair
Some of these develop gradually over years. Others show up after a single dry summer. If you notice two or more, it’s worth getting a professional evaluation.
→Diagonal cracks running from door or window corners through the drywall or sheetrock
→Interior doors that drag, stick, or won’t latch properly when they used to close fine
→Stair-step cracks in exterior brick, following the mortar joints
→Floors that slope or feel uneven when you walk from room to room
→Gaps forming between walls and ceilings, or between window frames and the surrounding wall
→An unexplained increase in your water bill, which can indicate a slab leak caused by foundation movement
A single hairline crack in an older Hurst home doesn’t always mean trouble. Concrete cracks as it cures, and that’s normal. What matters is whether your slab is actively moving. We determine that with elevation data across the full footprint of your home. If it’s just cosmetic, we’ll let you know and save you the money.
How Stratum Repairs Hurst Foundations
Recent Hurst Project
Redbud Estates, Built 1972
A homeowner on Redbud Drive contacted us about doors that had started sticking throughout the house and a crack that had opened up along the south-facing brick wall. The home was built in 1972 on clay-over-limestone typical of central Hurst. Our elevation survey showed 1.75 inches of settlement along the south and west corners, with the clay dried out and pulled away from the perimeter beam on the south side where two large oak trees were drawing moisture.
We installed 14 ST1 piers along the south and west perimeter, brought the slab back within a quarter inch of level, and finished by early afternoon. Total cost was $5,200. The homeowner called back the next week to say the hall bathroom door was closing properly for the first time in two years.
What Our Crews See Most in Hurst
Hurst is a mid-cities market where we see a consistent pattern: 1960s and 1970s ranch homes on conventional slabs, sitting on a thin layer of Blackland clay over Goodland Limestone. That clay-over-rock profile means the reactive zone is shallower than what we find in deeper clay markets like Richardson or Mesquite, but the movement is still significant enough to crack slabs and shift perimeter beams. The typical Hurst repair involves 10 to 14 piers, and the ST1 system actually works well for many homes here because the limestone provides a solid bearing surface at moderate depth.
The Redbud Drive and Pipeline Road corridors are our busiest areas in Hurst. The homes there are predominantly 1,200 to 1,800 square feet, single-story, with short perimeters. That keeps pier counts and costs lower than in the larger-home suburbs to the north. Most Hurst jobs come in between $3,800 and $7,500. The challenge in Hurst is the mature tree canopy — these neighborhoods were planted 50 years ago, and the oaks and pecans now have massive root systems that extend well under slabs. We see tree-driven differential settlement on nearly every Hurst inspection.
Hurst also has an older plumbing infrastructure. Many homes still have original galvanized supply lines and cast iron drains under the slab. When clay movement cracks a drain line, the water leak creates localized swelling that compounds the settlement problem. We recommend plumbing pressure tests for Hurst homes built before 1980 as part of the diagnostic process — it saves homeowners from fixing the foundation only to have a hidden leak cause new movement six months later.
Every Hurst home is different, and the right pier depends on what’s going on underground. We carry three systems. Your inspector will recommend the one that fits your soil depth, your home’s load, and how much the slab has already moved.
Most Affordable
ST1 System
Concrete Pressed Piers
Starts with 1 ft of steel, then all concrete. 11,980 PSI cylinders, nearly 2x stronger than the industry standard. Works well for Hurst homes where the Goodland Limestone sits close to the surface and the clay layer above is relatively thin.
Starts with 3 ft of steel, then concrete. Punches through shallow hard layers and reaches about 50% deeper than the ST1. This is our go-to for Hurst homes near the Trinity River floodplain where the clay deposits run deeper and the limestone base is further down.
Starts with 10 ft of double-walled steel, reaching about 2x the depth of the ST1. We reserve this for severe cases with deep active clay or where the bedrock surface is irregular. Some homes in southern Hurst near the Bear Creek drainage need it because the soil transitions are unpredictable at depth.
Most Hurst jobs wrap up in one day. Our crew digs at each pier location along the perimeter, drives the pier to refusal, and lifts the slab back toward its original position. Steel brackets lock everything in place. Every hole is backfilled and compacted before we leave. You can stay in the home the whole time.
Your free lifetime transferable warranty starts the day we finish. If you sell your house later, the warranty transfers to the buyer at no cost. We also offer 0% interest financing with 6, 12, or 24-month terms and no payments required.
Find Us Near Hurst
Our nearest office to Hurst is the Dallas location at 14875 Preston Rd Suite 550, Dallas, TX 75254. Open Monday through Friday, 7:30 AM to 6:00 PM. About 25 minutes from Hurst.
Hurst Neighborhoods We Service
We work throughout Hurst and the surrounding HEB area. These are the neighborhoods and communities where we’ve done the most repairs.
Redbud Estates Bellhaven Park Shady Oaks Midway Park Hurstview Precinct Line Estates Heritage Glen Capewood Indian Hills Brookside Chisholm Trail Souder Addition Cannon Industrial Pipeline Corridor North Hurst
Foundation Repair FAQs — Hurst
Most Hurst foundation repairs fall between $2,500 and $15,000. The total depends on how many piers your home needs and how far the slab has settled. We offer 0% financing for up to 24 months with no payments.
Hurst sits on the Goodland Limestone formation with weathered clay layers on top. The clay swells when wet and shrinks when dry, while the limestone underneath stays put. That mismatch puts constant stress on your slab. On top of that, most Hurst homes were built in the 1960s and 1970s with less reinforcement than modern code requires, so the slabs are reaching an age where they need support.
Diagonal cracks in drywall near door and window corners. Doors that stick or won’t latch. Stair-step cracks in exterior brick along the mortar joints. Floors that slope or feel uneven. Gaps between walls and ceilings or around window frames. An unexplained jump in your water bill, which can point to a slab leak caused by foundation movement.
Yes. Every inspection is free, no obligation. We take elevation measurements across your full slab, check your drainage and grading, and evaluate the soil conditions. You get a written report with everything we find. If you don’t need repair, we’ll tell you. Our nearest office is the Dallas location at 14875 Preston Rd Suite 550, about 25 minutes from Hurst.
Most repairs finish in a single day. The crew digs at each pier location, presses the piers to refusal, and lifts the slab back toward level. Steel brackets hold everything in place. All holes are backfilled and compacted before we leave. You do not need to move out.
We use three systems: the ST1 (concrete pressed piers, most affordable), the ST3 (steel and concrete hybrid, best for deeper clay near the Trinity floodplain), and the ST10 (deep steel piers for severe settlement or irregular bedrock). Your inspector picks the right one based on your soil conditions and how much movement has occurred.